U121F Engine Code Repair
Meaning of U121F engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.
U121F Fault Symptoms :
- Check engine light comes on
- Engine stalling or misfiring
- Engine performance issues
- Car not starting
If one of these reasons for U121F code is occuring now you should check U121F repair processes.
Now don't ask yourself; What should you do with U121F code ?
The solution is here :
U121F Possible Solution:
Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.
U121F Code Meaning :
U
OBD-II Diagnostic Network (U) Trouble Code For Engine
1
Fuel And Air Metering
2
Fuel Rail/System Pressure - Too High
1
Cold Start Injector 1 Malfunction
f
Regarding the U121F code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.
U121F OBD-II Diagnostic Network (U) Trouble Code DescriptionU121F engine trouble code is about .Main reason For U121F CodeThe reason of U121F OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High. |
U121F DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.